Universal Hacks to Fix Netgear WiFi Extender Reset Failed Issue

• You have connected your Netgear range extender to a damaged wall socket due to which it is not getting an adequate power supply.
• For the device to get restored, the reset hole should be pressed for a minimum of 30 seconds. But, if you did not wait for enough time, it is obvious why you are here.
• You did not follow the correct steps to restore your networking device to its default mode or perhaps you skipped one or two in between.

Now, you ought to get down to the effective solutions highlighted further in this post and gain an understanding of how to resolve the issue in debate.

[Fixed] Netgear WiFi Extender Reset Failed Issue

Reset the Extender Again

As mentioned above, perhaps you followed the wrong instructions due to which you are experiencing the Netgear WiFi extender reset failed issue. In view of this, you should try to reset your networking device again. To execute the process, locate the reset button on the wireless range extender. Once you find the button, press it with the assistance of an oil pin. Keep holding the button for about 5 minutes.

Now, check if you are able to resolve the Netgear WiFi extender reset failed issue or not. In case, you are still experiencing it, then following the next tip is suggested.

Wait as Much as Required

Considering you are reading this hack can mean just one thing, i.e. the Netgear WiFi extender reset failed issue is still behind your back. This might be because you did not wait enough when you were supposed to. From 30 seconds to 5 minutes, it is very important to wait as it gives enough time to the device to reset. Taking this into consideration, be patient and wait after pressing the power button. You need to wait till the time the LED lights located on the networking device do not start flickering.

Check the Electrical Socket

Is the wall socket to which your extender is connected damaged? If yes, then you need to get it repaired. This can be done if you call up an electrician at your home and get the existing wall socket repaired. Although repairing the wall socket by calling an electrician home will help you out, by any chance, if it does not, then you may consider connecting the networking device to another wall outlet.

In case this hack does not bring you luck, then it is recommended that you do not worry. Just consider doing what you already know is needed of you.

Replace the WiFi Extender

Despite following all the tips mentioned above, are you still not able to fix the Netgear WiFi extender reset failed issue? Well then, it means that there is something wrong with your extender itself. In this case, you need to replace it with a new one. You should know that if you are planning to get a replacement without paying any money, then it is only possible if your device is under warranty. Otherwise, you will have to empty your pocket for sure. After following this hack, try to restore your device to its default mode.

The Bottom Line

With that, we are ending the guide written on how the Netgear WiFi extender reset failed issue can be troubleshot. Now that you have successfully restored your device to its default factory mode, then you should set it up from scratch using any method that you like, whether it is the WPS method, the manual method, or the Nighthawk app.